At the read of the part instead of a tab on one side there is a recess as you can see in this pic.
If you put oneside up against a straight edge you can see all the tabs line up and the edge is parrallel.
When you flip the part over you can see where the tab should be there is a recess, and the edge of the part is not parrallel.
It's only one part, and really is fairly easy to repair by cutting the edge parrallel again. I'd say that there was just an error when the CAD drawings were done, or when they were transferred for CNC consumption.
No matter, we'll fix it up and send AMR a note.
Meanwhile, I've attached the rear top fuse stringers, the wing mounting blocks, fuse reinforcement and hatch lid.
No comments:
Post a Comment